Toilet Water Shut Off Valve Leaking Australia

I can see after watching this video that i need to get back there clean everything up possibly pull off the trim.

Toilet water shut off valve leaking australia.

Water will stop flowing into the tank. Do not remove the valve just tighten the packing nut. Tighten the packing nut. If there is a leak shut off the water empty the lines and unscrew the valve s compression nut.

First shut off the water to the leaking water valve. Remove the old washer and slide on the new one. Place a bucket or a thick towel on the floor under the leaky valve just in case some residual water leaks out during work. Wrap the slip joint pliers jaws in masking tape to protect your shut off valve from any scratches caused by the sharp edges.

Place the small container underneath the valve in case some water leaks into it while you do the repairs. Water leak shut off valve fixing for a leaky toilet water shut off valve the easiest solution is to tighten the package nut 1 4 turn with a wrench. As the water begins filling the toilet s tank check for leaks around the new valve. To fix a leaking flapper valve turn the water shut off valve on the intake pipe just below the toilet tank to the closed position.

Reinstall the packing nut tighten lightly with a wrench don t over tighten at this or any other point and reattach the handle. Use light steady pressure so you don t damage the water lines. When you re ready to get started shut off the water. Tighten the packing nut on the toilet shutoff valve one eighth turn clockwise to try to seal a leak around the nut.

Then follow our step by step instructions on our article. Step 3 remove the screw in the center of the shutoff valve handle using a screwdriver. Next remove the handle from the stem and then loosen and remove the packing nut. Next shut off the main water supply to the toilet and detach and drain the pipes using a wrench or pliers.

Flush the toilet and then remove the flapper valve. How to replace a toilet seal in 16 steps. Then flush the toilet to empty the tank. The chain hook must be removed and a new flapper set into its place.

Step 3 remove the nut. The small plastic tub will catch the water from the pipes to avoid spillage. I replace an old valve that was leaking. It is located inside the toilet tank at the bottom.

You can do this by turning the valve by the toilet base clockwise.