Tower Lightning Rod Installation

Use wide copper strap with the same ground rod spacing used in the tower.

Tower lightning rod installation.

There is enough soil for the tower ground system to absorb the bulk of the energy from the strike. The top of the light terminal shall be installed at least 2 meters over the area that it protects including antennas refrigerating towers roofs and tanks. Contact lightning master corporation at 800 749 6800 and set up an appointment today. This type of arrangement permits lightning strike charges to flow not only through the mast or structure but through the attached sensitive equipment as well.

As the installation of lightning rods is a protection system it is very important that it is performed by technically qualified personnel and under the current regulations. Lightning eliminators has been protecting communication towers around the world for over 43 years and has witnessed first hand the advancements and changes that have occurred due to innovation. For towers located closer than 50 from the house a strap should be also run from the tower ground system to the single point ground point at the service entrance of the home. With this in mind lec has created a solution which makes it easy to implement a complete lightning protection system specifically designed with a tower s safety and operations in mind.

Any communication equipment exposed to the elements especially communication towers need immediate lightning protection. Conventional practice has been to place lightning rods or air terminals directly on the structure of outdoor air handling units stacks control boxes and antenna cctv and lighting masts. Nature the down conductors may be tapes tape braid stranded wire or solid round. Contact lightning master corporation for communication tower lightning protection.