Traffic Light Controller Using Arduino In Proteus

In this video i am showing you how to make traffic lights using proteus simulator.

Traffic light controller using arduino in proteus.

You can see i have just placed an arduino board and plugged three leds with it and obviously they are green yellow and red in color. It uses code as an internal timer and continues to run until you cut the arduino s power supply. Published on nov 8 2018 in this video you are going to see the simulation of an automatic traffic light controller using 8051 microcontrollers in proteus software. This arduino based 3 way traffic light controller is a simple arduino diy project which is useful to understand the working of traffic lights which we see around us.

Here have demonstrated it for 3 sides or ways. The main part of this project is the arduino which will control the leds and their timings to guide the vehicles. Arduino software and library. Like subscribe and share.

Components we need is. The working of the project is very simple and is explained below. And the source code used in. Traffic light using 555 timer ic in proteus.

In this project will design a traffic light signal based on arduino uno in proteus with a simple program to displaying the proper indication sane as attached at a crossroads in cities to signify stop for red wait for yellow and green for go. Links to buy components. This simple little project uses an arduino and some leds to replicate a traffic light. This traffic light controller will be used to control the flow of traffic.

First of all design a circuit in proteus for traffic signal control using arduino as shown in the below figure. The aim of the project is to implement a simple traffic light controller using arduino uno where the traffic is controlled in a pre defined timing system. These can be applied at high traffic areas to avoid traffic blocks or accidents. Its quite a simple project so the circuit is quite simple as well.